Dekema AUSTROMAT 674 baSiC - 6.6. Backup and Restore Firing Programs; 6.6.1. Backup to USB Stick

AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
6. Operation
Operating Instructions (Version 03/2018) 97
6.6. Backing up and restoring firing programs
For reasons of data security and to prevent the loss of firing programs, it is recommendable to
regularly back up your firing programs:
• With a conventional USB stick (USB interface on the back of the firing furnace):
• Backup (see section 6.6.1),
•
Re
storing data (see section 6.6.2),
• You sho
uld at least note down your firing program parameters on paper or print it out.
6.6.1. Backup with a USB stick
Use the following procedure to back up the current program list ("set") on a USB stick.
1. Insert a USB stick into the USB port in the back of the firing furnace.
2. Open the Program Manager.
3. Click the button [Transfer set]. The “Select type of transmission” window opens.
Fig. 6-3 Program Manager > Transfer set
4. To back up the data, select the transmission type “Save to USB stick”.
• “Load from the Internet” downloads a set from the Dekema website,
• Only available when connected to the FTP server:
"Load from FTP server" downloads a set from the FTP server,
• Only available when connected to the FTP server:
"Load to FTP server" saves a set on the FTP server,
• “Load from USB stick” uploads a set from the inserted USB stick,
• “Save to USB stick” saves a set on the inserted USB stick.