AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
6. Operation
Operating Instructions (Version 03/2018) 91
6.3. Select programs and start them
6.3.1. With the touchscreen
1. After turning on the firing furnace, the Program Manager automatically appears on the
touchscreen. Select the desired program (see section 5.3).
Alternatively you can us
e the Icon Manager in order to select the required program, see
section 5.4. In this case skip the next step.
2.
Click on [Sele
cted program] in the Program Manager. The firing of the selected program is
displayed (program display, see section 5.5).
3. Click the prog
ram display [Program start]. The program is processed automatically (see
section 5.6).
4. While the p
rogram is running, the lift automatically moves up and down. Make sure that no
objects are in the way that could hinder the lift movement. Also do not attempt to manually
stop or accelerate the lift.
5. While the program is running, you can stop the program by clicking [Cancel program].
6.3.2. With web interface (optional)
NOTE:
This functionality is available as an option.
• The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.8.2.1).
• You can find
information
on enabling options in section 7.6.
NOTE:
To operate the firing furnace using the web interface, your browser must be Java-
capable, and the Java application must be activated.
Start Web interface
1. Start the browser on the computer.
2. Click on the bookmark for the firing furnace (if available), or enter the IP address for the
firing furnace in the address line of the browser (see section 4.5).
3. Enter your lo
gin data, that is, the password. The Program Manager opens (see section 5.3).
The remainin
g procedure is the same as that in section 6.3.1.
To Next Page
Loading...