6. Operation AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
90 Operating Instructions (Version 03/2018)
NOTE:
Stack the levels as precisely as possible. The levels may not tilt. Given the dimensional
tolerances, the sinter plates and sinter rings may tilt when stacked. Make sure that this
does not happen since the insulation may be contacted while the lift is being closed
causing undesirable wear.
• Place the firing object on the sinter ring, and place the sinter plate in the middle of the
insulation table.
• When positioning the firing object, ensure that no parts jut out over the edge of the top
sinter plate. There is a danger of damaging the firing object and thermal insulation material
when closing the firing furnace.
Removing the firing object
• Use suitable tools (tweezers) to remove the firing objects, or wear safety gloves.
To Next Page
Loading...