Dekema AUSTROMAT 674 baSiC - 4.5. Network Connection (Optional); 4.5.1. Determining the IP Address

4. Start-up AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
32 Operating Instructions (Version 03/2018)
4.5. Connect the firing oven to the network (optional)
NOTE:
This functionality is available as an option.
• The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.8.2.1).
• You can find
information
on enabling options in section 7.6.
• The unit sha
ll not be connected directly to TNV networks.
Overview of the procedure
1. Determine the IP address of the firing furnace (see section 4.5.1).
2. Set up remot
e access to the firing furnace (operation):
• Access through a browser. To do this, Java must be installed on a computer and the
browser must be a Java-enabled (see section 4.5.2).
•
Acce
ss via a VNC program. A VNC program must be installed on your computer (see
section 4.5.3).
3.
Set up a permanent IP ad
dress for the firing furnace (see section 4.5.4).
4. Establish access right
s for users of the firing furnace (see section 4.5.5).
5. If desired: e
stablish the type of remote access (through a browser or VNC program) (see
section 4.5.6).
4.5.1. Determine the IP address
NOTE:
Consult your network administrator if you are uncertain.
1. Make sure that the firing furnace is connected to the Ethernet (interface for the network
cable on the back of the unit),
2. Turn on the firing furnace and confirm any error messages. After the furnace is turned on,
the Program Manager automatically appears.
3. Click on [Setup] > [Network] in the Program Manager. The window “Network settings”
opens.