5. User interface AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
60 Operating Instructions (Version 03/2018)
5.7.2. Creating a new program
Follow the procedure below to create a new program:
1. Double-click an empty memory in the Program Manager.
2. The alphanumeric keyboard window opens. Enter a program name.
3. Edit the new program. You can find programming suggestions in section 5.7.3.
4.
Subse
quently change the program name: Click the field for the program name. The
alphanumeric keyboard window opens.
5. In the program display, click [Save] to save the changes.
5.7.3. Programming Suggestions
You can find non-binding programming suggestions at http://www.dekema.com. The programs
are firing programs converted according to manufacturer’s instructions for DEKEMA dental
ceramic furnaces of the AUSTROMAT
®
series. You can load these programs into your firing
furnace (see section 6.8.4).
The paramet
ers such as heating rates, temperatures and hold times indicated by the respective
manufacturer are transferred to the programs. These quantities depend on the conditions of use
such as the size and material of the firing tray or soft firing cushion, the size and weight of the
fired object, or the firing oven used when the ceramic manufacturer was determining the firing
parameters.
To Next Page
Loading...