Dekema AUSTROMAT 674 baSiC - 4.2. Setup Site Requirements

4. Start-up AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
28 Operating Instructions (Version 03/2018)
4.2. Requirements at the setup site
NOTE:
The following instructions must be followed each time the firing furnace is moved and
repaired.
NOTE:
Set up the firing furnace on a place where you can easily remove the power cable.
Firing furnace
The setup site of the firing furnace must meet the following requirements:
• Set up the furnace on a dry, flat, solid surface.
• The surface must be able to bear the weight of the firing furnace (see section 1.5).
•
Material
s and objects that can be damaged by heat must be sufficiently distant from the
firing furnace.
• The vents in the firing furnace must not be obstructed to enable the circulation of cooling
air.
• A power socket must be close to the device and easily accessible.
• The conditions in the environment at the setup site must meet the requirements in section
1.6.