AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
6. Operation
Operating Instructions (Version 03/2018) 103
6.8.3. Load a set from an FTP server (optional)
NOTE:
This functionality is available as an option.
• The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.8.2.1).
• You can find
information
on enabling options in section 7.6.
NOTE:
To load a set from an FTP server, the firing furnace must be connected to the FTP server
(see section 5.8.4.6).
The procedu
re for loadin
g a set from an FTP server is basically the same as loading a set from
a USB stick (see section 6.6.2).
Difference:
In the "Choose transmission method" window, select the option "Load from FTP server".
6.8.4. Download set from the Internet (optional)
NOTE:
This functionality is available as an option.
• The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.8.2.1).
• You can find
information
on enabling options in section 7.6.
Use the following procedure to download a s
et from the DEKEMA website.
1. Make sure that your internet connection is active.
2. Open the Program Manager.
3. Click the button [Transfer set]. The “Select type of transmission” window opens.
Fig. 6-9 Program Manager > Transfer set
4. Select the transmission type “Download from Internet”.
5. Click [OK] (press [ESC] to return to the Program Manager). You are automatically
connected to the DEKEMA website. The “Select set” window appears.
To Next Page
Loading...