6. Operation AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
94 Operating Instructions (Version 03/2018)
6.4. Program end
NOTE:
The firing chamber is closed generally at temperatures T > 999 °C. The chamber only
opens for chamber temperatures below 999 °C.
• While the program is running, you can stop the program by clicking [Cancel program]. In
this case, all the commands are stopped and the heat system is turned off. The firing
furnace cools down. The firing number is not increased during firing.
• An acoustic signal sounds after a regular program end.
• The lift moves down,
• The firing number is automatically increased,
• A log file for the firing is created and printed (if a printer is configured).
• You can remove the fired object (see section 6.2).
NOTE
:
If, after the firing program is over, the firing chamber is opened longer than 15 minutes
while the chamber temperature is above 200°C, a message appears and asks you to
close the firing chamber to prevent wear.
• Acknowledge the message.
• Close the firing chamber.
To Next Page
Loading...