AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
6. Operation
Operating Instructions (Version 03/2018) 89
6.2. Mounting and removing a firing object
WARNING
Hot surfaces.
The firing chamber can reach temperatures above 1,500°C
during operation. There is an extreme burning hazard from
touching hot surfaces after the firing chamber is opened.
Never directly contact hot parts of the firing furnace. The firing
furnace requires several hours to cool after it is turned off.
Observe the following instructions:
• Do not use your hands or any objects to grasp things in the
firing chamber,
• Do not grasp the lift seat, insulation table or firing objects
with your bare hands,
• Use suitable tools (tweezers) to remove the firing objects, or
wear safety gloves.
Mounting the firing object
• Place the sinter plates and sinter rings on the insulation table:
• Mount the wave-shaped sinter ring and optionally cover it with an sinter plate. This unit
forms one level.
• Create up to two levels as needed.
• Cover the top level with another sinter plate if desired.
Fig. 6-1 Stacking the levels (example of two levels)
1 Insulation table
2 Sinter ring
3 Sinter plate
To Next Page
Loading...