AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
5. User interface
Operating Instructions (Version 03/2018) 47
Left function bar
The buttons in the left function bar refer to sets of firing programs.
[Load set]: Opens the window "Select manufacturer" to load the programs of the
set into the Program Manager.
{Save set]: Saves the loaded set. After it is saved, the message appears:
"Successfully saved". Click [OK] to close the message.
[Transfer set]: Transfers a set to the Program Manager. Note that existing
programs are overwritten.
[GO TO]: Opens the numeric keyboard window so that you can select a
program by its number.
Right function bar
The buttons in the right function bar refer to individual firing programs.
NOTE:
Programs that are protected by the general code cannot be deleted or overwritten (see
also the section 5.8.1.6).
[Copy] Copies the selected program. Procedure:
• Select the desired program (source).
• Click on [copy].
• Select the number of the program to which the program should
be copied (target);
• Click on [Insert].
[Paste] Inserts a program. This function is only relevant along with the
commands [Copy] or [Cut].
[Cut] Moves the selected program. Procedure:
• Select the desired program (source).
• Click on [Cut].
• Select the number of the program where the program should be
moved (target);
• Click on [Insert].
[Delete] Deletes the selected program. Procedure:
• Select the desired program.
• Click on [Delete].
• A confirmation message is displayed. Click [OK] if you want to
delete the program.
[Shift] For selecting several programs. Procedure:
• Select the first desired program.
• Click on [Shift].
• Select the last desired program.
The entire block between the first and last program is selected and
can be copied, inserted or deleted.
To Next Page
Loading...