AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
5. User interface
Operating Instructions (Version 03/2018) 85
Backup data
Follow the instructions under "Backup" in the "Backup / Recovery" window.
NOTE:
All data on the thumb drive are deleted at the start of the backup.
1. Insert a USB stick (make sure there is enough free memory) into the USB port in the back
of the firing furnace.
2. Click on [Backup Start]. All the data of the firing furnace (operating system, software, set
parameters and firing programs) are written to the USB stick. A progress bar indicates the
remaining time until the backup is completed.
3. Wait until an acknowledgment beep sounds. It signals the conclusion of the backup
process.
4. Remove the USB stick.
You have successfully backed up the firing furnace data. If data is lost, you can restore the data
with the USB stick. Be sure to carefully store the USB stick and do not accidentally overwrite the
backed up data.
Restoring data
Follow the instructions under "Recover" in the "Backup / Recovery" window:
1. Insert the USB stick with the backed up data into the USB port in the back of the firing
furnace.
2. Click on [Recovery Start]. All the data of the firing furnace (operating system, software, set
parameters and firing programs) are restored.
3. Wait until an acknowledgment beep sounds. It signals the conclusion of the recovery
process.
4. Remove the USB stick.
You have successfully restored up the firing furnace data.
NOTE:
You can restore the data in the same manner as when updating a program
(see section 7.5).
Observe the f
o
llowing procedure:
1. Turn off the firing furnace,
2. Plug the thumb drive with the backup data into the USB port.
3. Turn on the firing furnace. While booting up, the firing furnace restores the backup.
4. Withdraw the thumb drive once a corresponding message appears on the screen.
The firing furnace then reboots and is ready to use.
To Next Page
Loading...