Part IV: System Functions
33-2 Managing Projects
From the auto test main screen (press
Auto
), all auto test projects and work orders saved to the DS2831 can
be seen.
33-2.1 Start
Highlight a test project from the list and press
Start
(F7) to run the auto test as designed. Before the testing
starts, you will be prompted to name the save data that will be collected. Use the alphanumeric keypad to
enter a name, then click Save to proceed.
During an auto-test project, a progress bar (%) indicates the status of the test. The test can be aborted at
any time by pressing
Stop
(F1) and confirming
OK
.
When the test concludes, you can view the data from the File Management screen (
File
). For specific
instructions, see Section 31-1.
33-2.2 Edit
Highlight a test project from the list and press
Edit
(F3) to open the auto test design screen. Here, you can
rename the project, re-assign its channel and limit plans, change its scheduled tests and test settings, and
other operations. See Section 33-1 for details on designing an auto test project.
33-2.3 Sort
You can re-sort test plans by pressing
Sort
(F4). In the sort dialog, navigate and select with the rotary knob.
Place a check next to “Project” to sort alphabetically, and “Date&Time” to sort by timestamp. Use the radio
button to select Ascending or Descending order.
When you have finished changing settings, press
OK
to sort files as specified.
33-2.4 Delete
Highlight and click an auto test project with the rotary knob to select it. Select one or more test projects from
the list and press
Delete
(F6) to erase it from the DS2831. You will be prompted to confirm the deletion. Click
OK
to confirm or
Cancel
to go back.
33-2.5 Export
To transfer an auto test project to USB, connect a USB storage device to the DS2831’s top panel. Auto test
projects can be exported from the file management screen (
File
). For specific instructions, see Section 31-2.
To Next Page
Loading...
