Part II: Settings and Measurements
TR 101 290 Priority 1, 2 and 3 Parameter Limits
You can set measurement limits on TR 101 290 Priority 1, 2 and 3 tests, applying them to real-time TS analysis.
(See above.) Closing and re-opening the TS analysis mode will reset all limits back to default values.
PSI/SI Table Repetition Time
(complete table)
(single sections)
Channel Parameters Setup Other Parameters Setup
You can select from two standards: DVB and ATSC.
Choose DVB to view PSI/SI analysis, and ATSC to view
PSI/PSIP analysis (shown, right).
DVB (PSI/SI: Program Specific Information/ Service
Information)
ATSC (PSI/PSIP: Program Specific Information /Program
and System Information Protocol)
To Next Page
Loading...
