TEST ACTION APPLICABILITY
22 Turn the ignition off.
Remove the Fuel Pump Relay from the PDC.
Disconnect the Fuel Pump Module harness connector.
NOTE: Check connectors - It is critical that the connector is free from any
signs of corrosion or deformities
Measure the resistance of the Fuel Pump Relay Output circuit from the relay
connector to the fuel pump module connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Fuel Pump Relay.
Perform POWERTRAIN VERIFICATION TEST VER-1 - 1.6L.
No → Repair the open fuel pump relay output circuit.
Perform POWERTRAIN VERIFICATION TEST VER-1 - 1.6L.
329
STARTING
*ENGINE CRANKS DOES NOT START - 1.6L — Continued
To Next Page
Loading...
