OVERVIEW
VF8 DELTA/DELTA XL/KAPPA 28-3
The following devices require an MIB interface protocol for display on the bedside
monitor.
WARNING: The following table lists all of the peripheral
devices and related software versions that Dräger has
validated. Dräger cannot make any claim for the reliability of
the data for subsequent or previous software versions or for
any devices that have not been validated. In the interest of
patient safety and device performance, do not connect
devices to the monitor which have not been approved by
Dräger. The hospital is responsible for contacting Dräger to
determine the compatibility and warranty status of any
connection made to another manufacturer’s medical devices.
Device Supported Software Version
Dräger Cato Tested to published protocol Medibus
anesthesia devices 3.00/4.00
Dräger Julian
Dräger Cicero (B, C, EM)
Dräger Julian Primus anesthesia device
Dräger Zeus Tested to published protocol Medibus
for Zeus 3.n/4.n
Dräger Zeus Infinity Empowered
NOTE: With IDS version 5.1 no MIB converter is
required.
Tested to published protocol Medibus
for Zeus Infinity Empowered 1.n
Dräger Fabius CE Tested to published protocol Medibus
anesthesia devices 4.00
Dräger Fabius GS
Tested to published protocol Medibus
anesthesia devices 4.00
Dräger Tiro
Dräger Primus
Note: This device is not sold in the United States.
Tested to published protocol Medibus
for Primus 1.n/2.n with software version
4.03.
Dräger Apollo Tested to published protocol Medibus
1.n, 2.n, and 3.n
Dräger Narkomed IIC 1.30
Dräger Narkomed IV 2.01
Dräger Narkomed 6000 4.01
Dräger Narkomed 6400 4.01
Dräger Babylog ventilator 5.00
Dräger Evita 1 ventilator Tested to published protocol Medibus
Intensive Care 3.00/4.00
Dräger Evita 2 ventilator 2.00
Dräger Evita 4 ventilator 03.21
Dräger Evita XL ventilator 05.00
To Next Page
Loading...
