Dräger Infinity Delta - Recorder Setup; Quick Reference: R50 Series Setup Menu

7-8 DELTA/DELTA XL/KAPPA VF8
7 R
ECORDINGS
Recorder Setup
The monitor prints recordings on a bedside R50
recorder (see illustration) or on a networked R50-N
recorder. The R50-N recorder, used for printing
recordings over the network, looks similar but is
slightly larger. The
mm/s fixed key on the recorder’s
front panel (
Alternate Speed on older recorders)
allows you to change the recording speed while a
recording is in progress. The recorder stops briefly and
then restarts automatically at the new recording speed.
The Stop fixed key, also on the recorder’s front panel,
stops a recording in progress.
On the R50 Setup menu, you can customize a variety of recorder functions.
To access the R50 series Setup menu
1. Press the Menu fixed key to display the Main menu.
2. Click on
Monitor Setup.
3. Click on Recordings.
4. Click on R50 Setup to display the Setup menu.
Quick Reference: R50 Series Setup Menu
The functions listed on the R50 Setup menu are described below.
NOTE: The mm/s or Alternate Speed key only functions while a recording is in
progress.
Menu Selection Description Available Settings
Delay Determines the amount of pre-event
data included in the timed recording
• 6, 10, 15 s
This selected value cannot
exceed the selected Duration
setting.
Duration Determines the length of a timed
recording
• 6, 10, 15 s
This selected value cannot
exceed the selected Duration
setting.
Speed Determines the recording speed • 1, 6.25, 12.5, 25, 50 mm/s