ECG
VF8 DELTA/DELTA XL/KAPPA 29-3
Patient Cables
1. Clean the patient cables with a gauze pad moistened with a soap solution.
2. Dry thoroughly with a lint-free cloth.
3. To disinfect patient cables, wipe the cables with a gauze moistened with
diluted alcohol.
4. Dry thoroughly with a lint-free cloth.
ECG
Reusable ECG Electrodes
Periodically clean the electrode cup with a toothbrush. Use a soft brush under running
water to remove any gel residue. Wipe electrodes with a gauze pad moistened with a
soap solution.
1. Disinfect electrodes by wiping with a cloth moistened with diluted alcohol.
2. Dry thoroughly with a lint-free cloth.
ESU Block
Do not immerse or rinse the ESU block. Clean it with a cloth moistened with soap
solution. Read the operating instructions accompanying the ESU for additional
information.
CAUTION:
Do not immerse or rinse the monitor and its peripherals. If you accidentally
spill liquid on a device, disconnect the unit from the power source. Contact
your technical personnel regarding the continued safety of the unit before
placing it back in operation.
To avoid damaging the device, do not use sharp tools or abrasives. Never
immerse electrical connectors in water or other liquids. Avoid letting fluids
puddle near the edge of the screen while you are cleaning it.
CAUTION: Do not use disinfectants that contain phenol as they can spot plastics. Do
not autoclave or clean accessories with strong aromatic, chlorinated, ketone, ether, or
ester solvents. Never immerse electrical connectors or the NBP connector.
To Next Page
Loading...
Need help?
General
