NBP SETUP
VF8 DELTA/DELTA XL/KAPPA 13-9
Taking NBP Measurements
Single Measurements
To perform a single measurement:
Push the NBP START/STOP fixed key on front of monitor.
The cuff inflates, then deflates. When an NBP measurement is in progress, the
background turns white and the foreground turns black.
When the measurement is complete, a chime sounds (if selected by user) and new data
appears. To stop a single measurement in progress, push the NBP S
TART/STOP fixed
key.
Calibrate Mode Configures NBP calibration
CAUTION:
Only qualified DrägerService
personnel should access this
function.
If you leave NBP Cal Mode ON
accidentally, NBP will default to
an NBP inactive state. To restore
NBP to normal operating mode,
power cycle the monitor.
•OFF
•ON
NBP Alarms Accesses NBP alarms and
associated variables on Alarm
Limits table
Not applicable
NBP Chime Produces a tone when NBP
measurement is complete
•OFF
•ON
WARNING: Press the NBP Start/Stop fixed key to deflate the
cuff rapidly if an adverse effect occurs on the patient.
NOTE: If an NBP reading is undetermined, the value of the previous reading in the
parameter box is blanked or the value displays as ***.
Function Description Settings
To Next Page
Loading...
