Troubleshooting
Operating Instructions 867 - 04.0 - 03/2018 145
3105 Error U24 V short circuit • Disconnect 37-pin plug
• Replace control if error
is not corrected
• Test inputs/outputs for
24 V short circuit
3106 Error
U24 V (I
2
T) overload
• One or several
magnets defective
3107 Error Pedal not connected • Connect analog pedal
3109 Warning Operation lock • Check tilt sensor on
machine
3151 Warning Maintenance necessary
(operation cannot
continue unless
parameter t5114 is
reset)
• Service is urgently
required Service
Instructions
6353 Error Internal EEprom
communication error
• Switch off the control
• Wait until the LEDs are
off
• Switch the machine
back on
6354 Error External EEprom
communication error
• Switch off the control
• Wait until the LEDs are
off
• Check machine ID
connection
• Switch the control back
on
8401 Error Watchdog • Software update
• Machine ID reset
• Replace the control
Code
Error/
warning
Possible cause Remedial action
To Next Page
Loading...
