134 Universal Control Commands
TYPOGRAPHIC CONVENTIONS
This subsection describes the typographic conventions used in
descriptions of control codes and control commands throughout this
manual.
FORMAT
Spaces are never sent to the printer as part of the command. For
readability, the arguments of the command are shown separated by
spaces.
Character case is significant. For example, if R is shown as part of the
command, an uppercase R must be sent.
The format for entering each control code or control command is shown
as follows:
ASCII:
the sequence in ASCII character
Control:
the sequence in control characters
Decimal:
the sequence in decimal data bytes
Hexadecimal
: the sequence in hexadecimal data bytes
All four command formats are equivalent.
To Next Page
Loading...
Need help?
General