Troubleshooting
WARNINGS !
!
Hazardous voltages are present in the 4100 printer. With the enclosure
removed and power applied, hazardous voltage areas are present.
Equipment service must be performed only by service-trained personnel
who are aware of the hazards involved.
!
Double-Pole/Neutral Fusing. The 4100 printer contains two fuses in the
power receptable. It is possible for only one fuse to blow. If this occurs,
be warned that, even though the
POWER
indicator is not lit, some printer
electrical circuit may remain active. ALWAYS turn off the printer and
unplug the power cord before checking the cause of the blown fuse(s) and
before replacing the fuse(s).
!
Use only the fuses specified. Never use repaired fuses, and never short-
circuit a fuse holder.
To Next Page
Loading...
Need help?
General