E-18 Appendix E—Barcodes
END BARCODE COMMAND
The End Barcode command terminates the printing of barcode symbols.
The printer returns to printing characters in the font style in place prior to
receipt of the Start Barcode command.
End Barcode command must be in the following form:
ASCII:
SOH A z L Ø
Control:
CTRL
AA z L Ø
Decimal:
1 65 122 76 48
Hexadecimal:
01 41 7A 4C 30
Note
: The zero in the Stop Barcode command can be entered either as
the character Ø (zero, as shown) or as the decimal value zero.
To Next Page
Loading...
