216 Epson FX-100 Control Commands
ASCII: ESC 5
Control:
CTRL
[5
Decimal: 27 53
Hexadecimal: 1B 35
Cancels italics. Print returns to previous upright style.
TABS
ESC D Set Multiple Horizontal Tabs
ASCII:
ESC D (n1)...(n32) NUL
Control:
CTRL
[ D (n1)...(n32)
CTRL
@
Decimal:
27 68 (n1)...(n32) 0
Hexadecimal:
1B 44 (n1)...(n32) 00
Sets multiple horizontal tabs. A maximum of 32 tabs may be set with one
command. Note that this control command is terminated with a null byte.
This command clears all existing horizontal tabs. Therefore, to add one
tab, you must include all existing tabs plus the new one.
ESC D only sets the tabs. The Horizontal Tab control code, HT, causes
the printer to tab to each subsequent tab.
n denotes the character position of each tab. The valid range for n is from
1 to one less than the right margin minus the left margin. Send the values
of n in ascending order. An out of order tab value is interpreted as a
terminator.
The tabs are set relative to the left margin. An n value of 1 sets the tab
one character to the right of the left margin. A maximum value of n sets
the tab one character to the left of the right margin. Therefore, n is the
character position relative to the left margin, not the actual column
number.
To Next Page
Loading...
Need help?
General