Operator's Guide 29
SETTING TOP OF FORM
Note
: The configuration menu option for form length must be set correctly
before setting the top of form. (The factory default form length is
11 in.: usually set to correspond to 11 in. between horizontal
perforations.) If necessary, see "Form Length," Page 77 in the
Configuration section, to select a different length.
1. Use the paper positioning keys to move the paper to the desired top of
form position.
Paper Position Keys Paper Movement
With
Printer
Off Line
+
+
Up 1 Line
Up by 1/144 in.
Down by 1/144 in.
To Next Page
Loading...
