54 Configuration
1 0.5-in. increments, including A4 length of 11
2/3 in.
2 "EMULATION" does not appear as a configuration menu option if "Lock Character Set and
Emulation" is "On."
3 "CHARACTER OPTIONS" does not appear as a configuration menu option if "Lock Character
Set and Emulation" is "On."
4 Only applies if the "Epson Character Set" is "Epson" in the FX-100 emulation.
5 Only applies if the "Epson Character Set" is "IBM #1" in the FX-100 emulation.
6 Only applies if the "Epson Character Set" is "IBM #2" in the FX-100 emulation.
7 Only applies if the "IBM Character Set" is "IBM #1" in the Proprinter emulation.
8 Only applies if the "IBM Character Set" is "IBM #2" in the Proprinter emulation.
9 G0 is the default for "7 Bit DEC." G0 and G2 are the defaults for "8 Bit DEC." You can assign
different graphic map defaults for 7-Bit and 8-Bit DEC.
The following sections explain, in greater detail, the various setting options
within the printer’s configuration menu. Each option is listed in order
under its respective menu heading.
HELP
Status Print?
Pressing
YES
prints out the present default settings, similar to the printout
on Page 60.
Menu Tree?
Pressing
YES
prints out a profile of the configuration menu options.
"EMULATION" and "CHARACTER OPTIONS" do not appear in the
configuration menu tree if "Lock Character Set and Emulation" (Page 92)
is "On."
Non-Default List?
Pressing
YES
prints out a list of the present default settings which differ
from the original factory default settings.
To Next Page
Loading...
Need help?
General