72 Configuration
Lines/Inch
Pressing
YES
prints out the active line space setting:
•
6 lpi (factory default)
•
8 lpi
This sets the number of lines per vertical inch. For an 11 in. form, the
printer prints a maximum of 66 lines at 6 lpi or 88 at 8 lpi.
Form Length
Pressing
YES
prints out the active form length setting:
•
0.5 in. to 31.5 in. in .5 in. increments (11 in. is factory default)
•
11
2
/
3
in. (standard A4 length for continuous forms)
•
420.0 mm
•
297.0 mm
•
210 mm
•
148.5 mm
Normally, the form length is the vertical distance between horizontal
perforations. However, any evenly divisible or multiple of this length to the
half inch can be used. For example, if you print on fanfolded 1½ in. label
stock, you might want to set the form length to 1½ in. rather than the
actual distance between horizontal perforations.
*
*
12 in. is a standard vertical distance between horizontal perforations on some fanfolded label stock.
To Next Page
Loading...
Need help?
General