Operator’s Guide 201
DEL Delete Last Character
ASCII: DEL
Control: not applicable
Decimal: 127
Hexadecimal: 7F
Deletes the last character in the print buffer.
CAN Cancel Data in Print Buffer
ASCII: CAN
Control:
CTRL
X
Decimal: 24
Hexadecimal:
18
Cancels all data currently in the print buffer.
The right margin becomes the current print position.
ESC s Half-Speed Printing
ASCII:
ESC s (n)
Control:
CTRL
[s (n)
Decimal:
27 115 (n)
Hexadecimal:
1B 73 (n)
Starts or cancels half-speed printing. Half-speed printing causes the
printer to run at 50 percent of the normal speed. It is an effective way to
reduce print noise and improve horizontal alignment. n specifies whether
it is set or cancelled as follows:
n =1 or 49: Start half-speed printing
n =0 or 48: Cancel half-speed printing
The printer uses half-speed printing when the operator access door is
open.
To Next Page
Loading...
Need help?
General