230 IBM Proprinter Control Commands
ESC C NUL Length of Form in Inches
ASCII:
ESC C NUL (n)
Control:
CTRL
[ C NUL (n)
Decimal:
27 67 0 (n)
Hexadecimal:
1B 43 00 (n)
Sets form length to an integer number of inches n. n must be from 1 to
151. (See Note below.) The default is 11 in. The current form position
becomes the top of form when the printer receives this command.
If the bottom margin was previously set by the Skip Over Perforation
command (ESC N), the Length of Form in Inches command cancels the
bottom margin setting. Therefore, to re-establish the bottom margin after
Length of Form in Inches is set, send another Skip Over Perforation
command.
Note
: The IBM Proprinter allows a form length range of 1 < n < 180 in.
The IBM emulation in the 4100 printer allows a range of 1 < n <
151 in. An out of range value is ignored.
Example
REM SET FORM LENGTH TO 10 LINES
LPRINT CHR$(27);"C";CHR$(10);
To Next Page
Loading...
