Epson PowerLite 4100 User Manual

276 DEC LA210 Control Commands
ESC | Map G3 into Upper Data Bytes*
ASCII
: ESC |
Control
:
CTRL
[|
Decimal
: 27 124
Hexadecimal
:1B 7C
Maps the G3 character map selected with control command ESC + into
the upper data bytes, making that character map active for printing. (See
ESC + (n) for an example.)
To print only one character from the character map selected as G3, use
ESC O.
1
ESC N or SS2 Print Next Character from G2
ASCII
: ESC N (n)
Control
:
CTRL
[N (n)
Decimal
:2778(n)
Hexadecimal
:1B4E(n)
ASCII
: SS2 (n)
Control
: not applicable
Decimal
: 142 (n)
Hexadecimal
:8E (n)
Prints the next character from the G2 character map selected with control
command ESC *. n specifies the character to print. The value of n must
be from 0 to 127. G2 does not need to be currently active (that is,
mapped into the lower or upper data bytes) to use this command.
Both commands perform the same function. SS2 is valid only if "8 Bit
DEC" has been set in the configuration menu and if the C1 control codes
have been enabled using ESC SP 7.
This command is valid for printing one character only. To print
continuously from the G2 character map, use control sequence ESC n or
1
To print the upper data byte characters, the "8 Bit DEC" option must be set in the
configuration menu. If the "7 Bit DEC" option is set, these commands are stored in
memory but not invoked until "8 Bit DEC" is selected
.

Epson PowerLite 4100 Specifications

General

Brand	Epson
Model	PowerLite 4100
Category	Projector
Language	English