Operator's Guide 287
BEL Bell
ASCII: BEL
Control:
CTRL
G
Decimal: 7
Hexadecimal: 07
Sounds the beeper for approximately 0.1 second.
The printer accepts up to ten sequential BEL commands; additional BEL
commands are ignored.
CAN Cancel
ASCII: CAN
Control:
CTRL
X
Decimal: 24
Hexadecimal: 18
Cancels any control function before it is finished. When received in
graphics mode, CAN returns the printer to text mode.
ESC SP 7 Enable C1 Control Codes
ASCII
: ESC SP 7
Control
:
CTRL
[SP 7
Decimal
:273255
Hexadecimal
:1B 20 37
Enables the printer to receive and interpret the C1 control codes, decimal
range 128 to 159, if upper data bytes have been enabled by selecting "8
Bit DEC" in the configuration menu. See the following command.
ESC SP 6 Disable C1 Control Codes
ASCII
: ESC SP 6
Control
:
CTRL
[SP 6
Decimal
:273254
Hexadecimal
:1B 20 36
Causes the MSB in C1 control codes, decimal range 128 to 159, to be set
to 0, effectively mapping control functions to them to C0, decimal range
000 to 031.
To Next Page
Loading...
Need help?
General