Epson S1D13706 - Page 343

Epson Research and Development
Page 7
Vancouver Design Center
Linux Console Driver S1D13706
Issue Date: 01/09/19 X31B-E-004-02
Building the Console Driver for Linux Kernel 2.4.x
Follow the steps below to construct a copy of the Linux operating system using the
S1D13706 as the console display device. These instructions assume that the GNU devel-
opment environment is installed and the user is familiar with GNU and the Linux operating
system.
1. Acquire the Linux kernel source code.
You can obtain the Linux kernel source code from your Linux supplier or download
the source from: ftp://ftp.kernel.org.
The S1D13706 reference driver requires Linux kernel 2.4.x or greater. The example
S1D13706 reference driver available on www.erd.epson.com was built using Red Hat
Linux 6.1, kernel version 2.4.5.
For information on building the kernel refer to the readme file at:
ftp://ftp.linuxberg.com/pub/linux/kernel/README
Note
Before continuing with modifications for the S1D13706, you should ensure that you can
build and start the Linux operating system.
2. Unzip the console driver files.
Using a zip file utility, unzip the S1D13706 archive to a temporary directory. (e.g.
/tmp)
When completed the files:
Config.in
fbmem.c
fbcon-cfb4.c
Makefile
should be located in the temporary directory (/tmp), and the files:
Makefile
s1d13xxxfb.c
s1d13706.h
should be located in a sub-directory called epson within the temporary directory
(/tmp/epson).
3. Copy the console driver files to the build directory. Make the directory
/usr/src/linux/drivers/video/epson.
Copy the files
/tmp/epson/s1d13xxxfb.c
/tmp/epson/s1d13706.h
/tmp/epson/Makefile
to the directory /usr/src/linux/drivers/video/epson.