Epson Stylus Pro 4450 - Page 168

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 168
PAPER CUT ERROR
COMMAND ERROR
WRONG INK ERROR
WRONG ROLL PAPER PATH / WRONG ASF PAPER PATH / WRONG MANUAL PAPER PATH
Note : Remote commands always have priority.
ASF PROHIBITIONS
LCD Explanation Recovery
PAPER NOT CUT It is occurred when top of roll paper cannot be detected by Multi
Sensor, after paper cut operation.
Release Paper Lever, remove paper, and pull down the lever.
LCD Explanation Recovery
COMMAND ERROR This error occurs when ink type (dye / pigment / black ink type)
designated with IK command is different from Ink Cartridge installed in
the printer.
Press [Pause] key after stopping data transmission from the host.
LCD Explanation Recovery
MISMATCH ERROR This error occurs when ink type (4 color/ 8 color) designated with IK
command is different from Ink Cartridge installed in the printer.
Install the correct Ink Cartridge displayed on the Panel LCD, and pull
down the Ink Lever.
DRIVER INK SET
SETTING IS WRONG
LCD Explanation Recovery
LOAD ROLL PAPER Different paper source is selected on panel from the paper source that
is selected by Remote command.
The path sent by command takes priority, and a message based on
the command designated path is displayed in the LCD if the printer
path is different.
If the panel setting differs to the actual paper, change the select paper
in the panel.
LOAD SHEET PAPER
IN P. TRAY
If the actually set paper differs, reset paper selected by PP command.
FEED SHEET PAPER Reset the panel by pressing the [Pause] key. In this case, the
mechanical parameters will follow the paper type default settings set in
the printer.
LCD Explanation Recovery
FORBIDDEN MEDIA
FROM P. TRAY
ASF is designated paper tray when command is received for printing
of media that is prohibited from being supplied by ASF, such as Water
Color Paper.
Reset panel by pressing [Pause] key.
FEED SHEET PAPER MANUARY