Epson Stylus Pro 4450 - Adjustment Program Basic Operation; Start-Up; Sequential Mode; Individual Adjustment Mode

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Overview 375
5.1.7 Adjustment Program Basic Operation
This section describes basic methods for operating the adjustment program.
 Operating Environment
 OS: Widows 98, Me, 2000, XP
 Port: USB port
 Printer driver and ESM3 have to be installed.
 Start-up
1. Double-click [adjwiz2.exe] to start the adjustment program.
2. Select the following items after the startup screen appears.
z Printer name
Select the model of the printer in use.
z Adj. Mode
Select whether to execute adjustments with the sequential mode
(Sequence) or to execute each adjustment individually (Individual).
3. Click [Start].
Figure 5-1. Adjustment Program Startup Screen
 Sequential Mode
This is a guide mode for executing the required adjustments in a set order
when a replaced part or unit is selected.
1. Select the replaced part or unit from the left column and click [Add].
2. Click the [OK] button.
Figure 5-2. Sequential Mode Screen
 Individual Adjustment Mode
This is a mode for executing each adjustment item individually.
1. Select the adjustment item to be executed and click the [OK] button.
Figure 5-3. Individual Adjustment Mode Screen
C A U T I O N
The adjustment program includes adjustment items to be
used other than on-site. Regarding on-site repairs, do not
execute adjustments other than those described in this
manual.