EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 294
4.2.8.3 Gutter, Ink
1. Remove "Fan, Blower" (p244).
2. Remove the two screws securing "Duct, Air, D" and remove "Duct, Air, D".
(Refer to Figure 4-118.)
C.B.S. (P2) 3x6: 2 pcs.
3. Remove the two screws securing "Duct, Air, A" and remove "Duct, Air, A".
(Refer to Figure 4-119.)
C.B.S. (P2) 3x6: 2 pcs.
4. Remove the screw securing "Gutter, Waste Ink". (Refer to Figure 4-119.)
C.B.S. (P2) 3x6: 1 pc.
5. Slide the "Gutter, Waste Ink" to the left, move it downward and then
remove it to the left side. (Refer to Figure 4-119.)
Figure 4-118. Duct, Air, D Removal
Figure 4-119. Duct, Air, A and Gutter, Waste Ink Removal
C A U T I O N
When removing the "Gutter, Ink", prepare pieces of cloth in
case the waste ink leaks or splatter inside the printer. Make
sure that the ink is not ejected from the ink ejection route
during the work.
Insert the shaft of the "Duct, Air, D" into the bearing hole
of "Gutter, Ink" to position the "Duct, Air, D".
Secure with screws after confirming that "Gutter, Waste
Ink" is closely fitted to the printer frame.
Duct, Air, D
Step 2
Duct, Air, A
Gutter, Waste Ink
Step 5
Step 4
Step 3
Closely Fitted Location
To Next Page
Loading...
