Epson Stylus Pro 4450 - Harness Routing; Harnesses on Left Side of Printer; PG Sensor Harness; CSIC; I;H Lever Sensor Harness

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 358
4.2.10 Harness Routing
This section explains cautions and points in routing the harnesses. Referring to
this section, route the harnesses correctly. For the sections that is not
described here, refer to the corresponding diassembly/assembly procedures.
4.2.10.1 Harnesses on Left Side of Printer
PG Sensor • Harness
 Should be secured with the parts below.
 Clamp: 1 pc.
 Acetate tape: 1 pc.
Figure 4-223. PG Sensor • Harness
CSIC / IH/ Lever Sensor • Harness
 Should be connected to the "C593_SUB-C Board" through under the sheet
as shown in the figure below.
 Should be secured with the parts below.
 Acetate tape: 2 pcs.
Figure 4-224. CSIC / I/H Lever Sensor • Harness
Acetate tape
Clamp
Get through under the sheet
Acetate tapes