Epson Stylus Pro 4450 - T&B&S (Cut Sheet); T&B&S (Cut Sheet) Screen

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Basic Adjustment 391
5.3.5 T&B&S (Cut Sheet)
This prints a special pattern and adjusts the printing position on the surface of
the paper.
 Paper Used
 Size: A4
 Type: Enhanced Matte Cut Sheet
 Specifications
 Top margin: 10 ± 1 mm
 Bottom margin:114 ± 1 mm
 Side margin: 10 ± 0.3 mm
 Procedure
1. Start the adjustment program and select [T&B&S (Cut Sheet)].
2. Click the [Print] button to print the adjustment pattern.
3. Measure the margins of the following three parts indicated with Figure
5-27.
 Top margin
 Bottom margin
 Side margin
4. Input the values measured in Procedure 3 to its corresponding edit
box.
 Top margin
 Bottom margin
 Side margin
5. Click the [Write] button and then click the [Print] button again to print
the adjustment pattern.
6. Repeat Procedure 3 and Procedure 4, and click [Write].
7. If the specification values are satisfied, click [Finish]. If not satisfied,
repeat Procedure 3 through Procedure 5 until they meet the standards.
Figure 5-26. T&B&S (Cut Sheet) Screen
Figure 5-27. Adjustment Pattern
C A U T I O N
 When measuring colors, place the adjustment pattern on
a flat surface.
 Make sure to perform the adjustment twice regardless
whether the value obtained from the first measurement
meets the specified value.
Side Margin
Bottom Margin
Top Margin
5 mm