Epson Stylus Pro 4450 - Screw Securing Gutter, Ink; Gutter, Ink Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 295
6. Remove the screw securing "Gutter, Ink".
(Refer to Figure 4-120.)
 C.B. (P1) 3x4: 1 pc.
7. Remove "Gutter, Ink" by following the steps below. (Refer to Figure 4-121.)
7-1. Slide "Gutter, Ink" to left side.
7-2. Move "Gutter, Ink" right side downward.
7-3. Pull out "Gutter, Ink" left lower side toward you.
Figure 4-120. Screw Securing Gutter, Ink
Figure 4-121. Gutter, Ink Removal
Make sure that "Push Spring, Absorbent Pad, Gutter" is
attached to "Gutter, Ink". If it has removed, install it as
shown in the figure below.
Push Spring, Absorbent Pad, Gutter
Assembly Catch
Assembly Catch
Gutter, Ink
C.B. (P1) 3x4
1
2
3