Epson Stylus Pro 4450 - Cover, Holder, IC, Right Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 314
21. Remove the two screws securing "Cover, Holder, IC, Right" and remove
"Cover, Holder, IC, Right". (Refer to Figure 4-152.)
 C.B.S. 3x6: 2 pcs.
Figure 4-152. Cover, Holder, IC, Right Removal
 When the "Ink Lever" is installed against the angle set
location as shown in the illustration, confirm that the two
holes of "Fan Gear, 34" form a line parallel to the bottom
of "Frame, Holder, IC".
 Align the two dowels on holder side with the two
positioning holes on the "Cover, Holder, IC, Right".
(Refer to Figure 4-152.)
Ink Lever
Holes
Parallel Alignment
Angle Set Location Fan Gear, 34
Frame, Holder, IC
Dowels and Positioning Holes
C.B.S. 3x6
Cover, Holder, IC, Right