Epson Stylus Pro 4450 - Fan, Blower; Paper Guide, Eject, Stacker Removal; Releasing Relay Harness

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 244
4.2.5.2 Fan, Blower
1. Remove the four screws securing the two "Paper Guide, Eject, Stacker"s
and then remove the two "Paper Guide, Eject, Stacker"s.
(Refer to Figure 4-51.)
 Installation Plate, Shaft, CR: 2 pcs.
 C.B.S. 3x8: 2 pcs.
2. Release relay harness connected to "Fan, Blower" (right) from acetate
tapes and clamp. (Refer to Figure 4-52.)
3. Disconnect the two rellay connectors as shown in Figure 4-52.
(Refer to Figure 4-52.)
Figure 4-51. Paper Guide, Eject, Stacker Removal
Figure 4-52. Releasing Relay Harness
Insert the two tabs of the "Paper Guide, Eject, Stacker" into
the two positioning holes on the "Frame, Fan, Unit".
Positioning Holes
Frame, Fan, Unit
Tabs
C.B.S. 3x8
Installation Plate, Shaft, CR
Paper Guide, Eject, Stacker
Relay Connectors
Acetate Tapes (x3)