Epson Stylus Pro 4450 - Print Head Slant Adjustment (PF); Print Head Slant Adjustment (PF) Screen

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Basic Adjustment 394
5.3.8 Print Head Slant Adjustment (PF)
 Papers Required
 Size: 16"
 Type: Premium Glossy Photo Paper
 Procedure
1. Turn the printer power on.
2. Start up the adjusting program and select [Print Head Slant Adjustment
(PF)].
3. Click [Print] to print the adjustment pattern.
Figure 5-31. Print Head Slant Adjustment (PF) Screen (1)
4. Seeing the pattern in the direction shown in Figure 5-32, check the
clearance gap between the second and the third blocks from the right.
(See figure 5-32) Measure the two intervals between the two blocks
which are located one line lower/upper than the two continued lines
with a magnifying glass with a scale.
z The gap is parallel to the both blocks (Pattern 2).
Click [Next] and click [Finish] on the next screen to complete
the adjustment.
z The gap is not parallel to the both blocks (Pattern 1, 3).
Click [Next] and perform adjustment on the next screen. → to
Procedure 5.