Epson Stylus Pro 4450 - Release Unit Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 347
12. Remove the two screws securing "Release Unit". (Refer to Figure 4-204.)
 C.B.S. 3x6: 2 pcs.
13. Pull right side of "Release Unit" toward you, completely remove the right
side of "Release Unit" while freeing the "Release Unit" ribs from the printer
frame cut-out, and then remove the "Release Unit" from the printer body.
(Refer to Figure 4-204.)
Figure 4-204. Release Unit Removal
Release Unit
Dowel and Positioning Hole
Dowel and Positioning Hole
Step 13
Ribs
C.B.S. 3x6 C.B.S. 3x6
Cutout