Epson Stylus Pro 4450 - Panel, Front;Panel Unit; Panel, Front Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 219
4.2.3.5 Panel, Front/Panel Unit
1. Remove "Cover, Side, Left" (p216).
2. Remove "Cover, Side, Right" (p217).
3. Remove "Harness, Panel" from "Panel Unit".
4. Remove following screws securing "Panel, Front". (Refer to Figure 4-21.)
 C.B.S. 3x6: 1 pc.
 C.B.S. (O) 3x6: 8 pcs.
 C.B.S. (O) 3x8: 1 pc.
5. Release "Panel, Front" dowel from positioning hole in frame.
(Refer to Figure 4-20.)
6. Remove "Panel, Front" toward you.
Figure 4-20. Harness, Panel, Connection Status
Figure 4-21. Panel, Front Removal
 Align "Panel, Front" dowel with positioning hole in
frame. (Refer to Figure 4-20.)
 Install "Panel, Front" to printer by tightening screws in
the order shown by number in Figure 4-21.
Step 3
Panel Unit
Harness, Panel
Dowel and Positioning hole
1
2
3
45
6
7
8
9
10
Panel, Front
C.B.S. (O) 3x6
C.B.S. 3x6
C.B.S. (O) 3x8
C.B.S. (O) 3x6