Epson Stylus Pro 4450 - PE Sensor Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 353
6. Release the two tabs securing "PE Sensor" and remove "PE Sensor" from
"Holder, Detector, PE".
7. Disconnect FFC from "PE Sensor".
Figure 4-215. PE Sensor Removal
Checking front and back of FFC and connect properly.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (p.366) and
perform specified adjustments after replacing the "PE
Sensor".
PE Sensor
FFC
Tabs