Epson Stylus Pro 4450 - Cleaning Setting for Nozzle Check; Super Low Speed Cut Mode; Level Structure of Cleaning Setting for Nozzle Check Menu; Level Structure of Super Low Speed Cut Mode Menu

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 57
1.4.4.16 Cleaning Setting for Nozzle Check
Nozzle check method is switched to either auto or manual.
When “Cleaning setting at nozzle check“ (=printer setting menu/auto cleaning)
is set to ON, auto nozzle check pattern printing is performed. When the
cleaning setting is set to OFF, manual nozzle check pattern printing is
executed.
The following shows the operations performed by each setting in "Cleaning
setting for nozzle check" and "Auto cleaning for each job".
Note *: The command that is sent from the printer driver to the printer in order to
control the nozzle check.
 Level structure of cleaning setting for nozzle check menu
1.4.4.17 Super Low Speed Cut Mode
When this setting is set to “ON”, normal cut operation is performed at 20CPS to
reduce a noise and paper dust. The default is set to OFF.
However when top edge is cut at Top/Bottom borderless printing
setting,(including top margin at 1 cut setting.)this setting is not reflected to
prevent irregular color by reducing cut speed.
 Level structure of super low speed cut mode menu
Table 1-29. Operation setting
Cleaning
setting for
nozzle check
Auto cleaning
for each job
Nozzle check
operation by
panel
Auto nozzle
check
operation
before Job
Nozzle check
operation
when sending
"NC" m1 = 80h*
OFF OFF Manual None Manual
ON OFF Auto None Auto
OFF ON Manual None Manual
ON ON Auto Execute Auto
[∧ / ∨]
[< / >]
[<]
PRINTER SETUP
AUTO CLEANING
AUTO CLEANING
ON
AUTO CLEANING
OFF
[∧ / ∨]
[∧ / ∨]
[< / >]
[<]
PRINTER SETUP
QUIET CUT
QUIET CUT
OFF
QUIET CUT
ON
[∧ / ∨]