Epson Stylus Pro 4450 - Destination Setting; Destination Setting Screen; Confirming Model Name

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Advanced Adjustment 434
5.4.3 Destination Setting
 Procedure
1. Turn the printer on.
2. Start the adjustment program and select [Change Model Name].
3. Select the "Others" and click the [Run] button to set the destination to
the NVRAM.
4. Click the [Next] button.
5. Click the [Check] button and current setting model name will be
displayed. Click the [OK] button after confirming the set model name.
6. Click the [Finish] button.
Figure 5-88. Destination Setting Screen (1)
Figure 5-89. Destination Setting
Figure 5-90. Confirming Model Name