Epson Stylus Pro 4450 - Ribs of Shaft, Connection; Shaft Part of Lever, Change Paper Eject, R; Spur Gear

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Maintenance Lubrication 454
Figure 6-11. Spur Gear 44.74
Figure 6-12. Shaft part of "LEVER, CHANGE PAPER EJECT, R"(No.1)
Figure 6-13. Shaft part of "LEVER, CHANGE PAPER EJECT, R"(No.2)
Figure 6-14. Ribs of "Shaft, Connection
• Lubrication Point
"Spur Gear 44.74", "Spur Gear 25.6",
small gear of "Combination Gear
12.8.36", and large gear of
"Combination Gear 16.74.24"
• Lubrication Type
G-26
• Lubrication Amount
F1mm x quarter circumference (4
places)
•Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
• Lubrication Point
"LEVER, CHANGE PAPER EJECT,
R;B", and contact sits and back of
"LEVER, CHANGE PAPER EJECT,
R"
• Lubrication Type
G-26
• Lubrication Amount
Φ1mm x 10mm (3 places)
•Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
Spur Gear 44.74
Combination Gear
16.74.24
Spur Gear 25.6
Combination Gear
12.8.36
Back of dot-line
part
Contact sites
(2 places)
• Lubrication Point
Shaft part of "LEVER, CHANGE
PAPER EJECT, R"
• Lubrication Type
G-26
• Lubrication Amount
Φ1mm x approximately 3mm
• Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
• Lubrication Point
Upper part of Ribs of "Shaft,
Connection"
• Lubrication Type
G-26
• Lubrication Amount
Φ1mm
• Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.