Epson Stylus Pro 4450 - Cut Sheet Size Error; Auto Nozzle Check for each Job; Level Structure of Cut Sheet Size Error Menu; Level Structure of Auto Nozzle Check for each Job Menu

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 56
1.4.4.14 Cut Sheet Size Error
When this setting is OFF, it will prevent the occurrence of size error and keeps
printing. It will not work for roll paper.
If the print image is bigger than the paper set by this setting, printer prints by
clipping the data that is out of paper. If this setting is ON, paper size in
horizontal direction and value read from detect paper width sensor set by paper
size setting command (ESC "(S") during receiving data are over +/-3mm, cut
sheet size error occurs. If paper size setting command does not exist during
receiving data, cut sheet size error never occurs.
 Level structure of cut sheet size error menu
1.4.4.15 Auto Nozzle Check for Each Job
This setting is valid only when "Cleaning setting at nozzle check" is ON. By
turning this setting on, auto nozzle check can be performed before printing
upon receiving data from PC. Trigger for receiving data from PC is when
receiving remote command "JS". If JS command is not send, auto nozzle
check is not performed. Also when paper is out during continuous print, display
"Paper out" and wait for paper set.
When user cannot check the nozzle clogging visually at day and night
automatic operation, the setting will be ON.
 Level structure of auto nozzle check for each job menu
[∧ / ∨]
[< / >]
[<]
PRINTER SETUP
PAPER SIZE CK
PAPER SIZE CK
ON
PAPER SIZE CK
OFF
[∧ / ∨]
[∧ / ∨]
[< / >]
[<]
PRINTER SETUP
AUTO NZL CK
AUTO NZL CK
ON
AUTO NZL CK
OFF
[∧ / ∨]