Epson Stylus Pro 4450 - Adjustment Pattern; T&B&S (Roll Paper)

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Basic Adjustment 390
5.3.4 T&B&S (Roll Paper)
This adjusts the printing position that includes the cut position on the surface of
the paper and corrects a bend of emission axis of the main scanning direction
in the multi sensor.
 Paper Used
 Size: 17"
 Type: Enhanced Matte Roll Paper
 Specifications
 Top margin: 10 ± 1 mm
 Bottom margin: 114 ± 1 mm
 Side margin: 10 ± 0.3 mm
 Procedure
1. Start adjustment program and select [T&B&S (Roll Paper)].
2. Click the [Print] button to print the adjustment pattern.
3. Refer to Figure 5-25, and measure the distance of the following three
positions;
 Top margin, bottom margin
Check the arrow direction of "T&B Position" printed on the pattern.
Then measure the distances of margins indicated with arrows in
Figure 5-25 for top and bottom.
 Side margin
Measure the distance as shown in Figure 5-25.
4. Input each of the following value into its corresponding edit boxes.
 The values measured in Procedure 3
 Top margin
 Bottom margin
 Side margin
 The values printed in the pattern lower part
 Multi sensor left
 Multi sensor right
5. Click the [Write] button and then click the [Print] button again to print
the adjustment pattern.
6. Repeat Procedure 3 and Procedure 4, and click [Write].
7. If the specification values are satisfied, click [Finish]. If not satisfied,
repeat Procedure 3 through Procedure 5 until they meet the standards.
.
Figure 5-24. T&B&S (Roll Paper)
Figure 5-25. Adjustment Pattern
C A U T I O N
 When measuring colors, place the adjustment pattern on
a flat surface.
 Make sure to perform the adjustment twice regardless
whether the value obtained from the first measurement
meets the specified value.
T&B Position : <-- MS Left : XX.XXX mm MS Right : XX.XXX mm
T & B Position : <
MS Left : XX.XXX mm
MS Right : X.XXX mm
--
Top Margin
(->)
Top Margin
(<-)
Bottom Margin
(->)
Bottom Margin
(<-)
Side Margin