Epson Stylus Pro 4450 - Solenoid, CR; Solenoid, CR Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 284
4.2.7.11 Solenoid, CR
1. Remove "Carriage Unit" (p266).
2. Attach the "CUTTER CAP" to the cutter section of the "Carriage Unit".
(Refer to Figure 4-110.)
3. Release the harnesses of the "Solenoid, CR" from the tabs of the "Carriage
Unit". (Refer to Figure 4-105.)
4. Remove the screw and the plain washer that secure the "Solenoid, CR",
and then remove the "Solenoid, CR" from the "Carriage Unit".
 C.B.P.(P2) 3x8 (+ plain washer 4.3x0.8x8): 1 pc.
Figure 4-105. "Solenoid, CR" Removal
C H E C K
P O I N T
The "Cutter Cover", which covers the cutter blade projecting
upward from the bottom of the Carriage, prevents injury
during the work.
Route the harnesses of the "Solenoid, CR" on the "Carriage
Unit" properly as shown in Figure 4-105.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (p.366) and
perform specified adjustments after replacing the "Solenoid,
CR".
C.B.P.(P2) 3x8
+washer 4.3x0.8.8
Tab
Tabs
CUTTER CAP
Solenoid, CR