Epson Stylus Pro 4450 - Roller Assy., LD, Left and Roller Assy., LD, Right Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 258
8. Remove the "E-ring, 6" from the "Shaft, Roller, LD".
9. Draw out the "Shaft, Roller, LD" to the direction shown in Figure 4-69 to
remove both the "Roller Assy., LD, Left" and the "Roller Assy., LD, Right".
Figure 4-69. "Roller Assy., LD, Left" and "Roller Assy., LD, Right"
Removal
All the parts shown in Figure 4-69 are released when
drawing the "Shaft, Roller, LD". Install the parts to the
"Shaft, Roller, LD" in the correct order and direction, refering
the Figure 4-69.
Roller Assy., LD, Right
Compression Spring, 0.407
Holder, Edge Guide, Left
Roller Assy., LD, Left
Shaft, Roller, LD
E-ring
Drawing Direction of Shaft
Compression Spring, 0.4
Roller, Sub, LD, Middle
Roller, Sub, LD, Middle
Compression Spring, 0.4